The Classic Range
Available In | Reverse Cycle – 2.5kW, 3.5kW, 4.2kW, 5.0kW, 6.3kW, 7.1kW, 8.0kW, 9.2kW |
Refrigerant |
R410A |
Key Features
The room temperature can be set to go no lower than 10°C, thus ensuring that the room does not get too cold when not occupied.
With All DC, electricity loss is decreased and power consumption reduced.
Fine dust, invisible mould spores and harmful microorganisms are absorbed onto the filter by static electricity and further growth is inhibited and deactivated by the polyphenol ingredient extracted from apples.
Should there be a temporary loss of power, the unit will automatically restart itself in the same operating mode, once the power is restored.
The auto shut louvres close or open automatically when the unit stops or starts.
The unit automatically switches between operating modes based on the temperature setting and room temperature.
The position of the louvres is set automatically to match the operating mode. It is also possible to adjust the louvres using the remote control.
Corrosion-resistance of the heat exchanger in coastal areas has been improved by blue fin treatment of the outdoor unit heat exchanger.
Limits the maximum operation current, and performs operation with the power consumption suppressed.
i-PAM inverter technology enables high output and high efficiency performance.
ON-OFF timer can be set to operate once every 24 hours.
This timer allows selection of one of four options. ON, OFF, ON ––> OFF, or OFF ––> ON.
The micro-processor gradually changes the room temperature, allowing you to sleep comfortably at night.
The indoor units fan can operate at a low speed to produce quieter operation.
The up/down louvre automatically swings up and down.
v-PAM inverter technology increases the maximum output of the compressor significantly and enables high power and high efficiency.
Dust that accumulates on the air conditioner can be easily cleaned with a damp cloth.
Weekly + setback timer can set temperature for two time spans and for each day of the week.
Different ON-OFF times can be set for up to 7 days.
Take control. Controller options.
This range is compatible with the following controller options.
AR-REA1E
The economy operation will save energy in heating, cooling and dry mode and is set by pressing the button on the remote control.
ON-OFF timer can be set to operate once every 24 hours.
Weekly + Setback timer can set temperature for two time periods and for each day of the week.
AR-RAH2E
Weekly Timer
Different ON-OFF times can be set for up to 7 days.
Economy Mode
The economy operation will save energy in heating, cooling and dry mode and is set by pressing the button on the remote control.
Weekly + Setback Timer
Weekly + Setback timer can set temperature for two time periods and for each day of the week.